Offroad-Express

Gidday all
I've struck a bit of a problem, I'm at the stage now where I'm putting all the pipes and vacum hoses back on the motor (all came off for the rebuild) and the american manual just dosn't match up ...

I was hoping some one might be able to take some pic's of there motors and mail em to me... so I've at least got a finished pic to build this jigsaw to

Cheers Reece

Bugger
Don't think I can help you sorry, wrong motor etc.

Best of luck.

Thomas

Hey maybe I can. Is this any good?
http://www.trademe.co.nz/Trade-Me-Motor ... d+1984.htm

I need a shot looking down ontop of the motor(so I can see which ones run to the bits on the firewall) and one looking in the intake side

its all the small hoses that lace all over the place that have me buggered if I know what half of them are there for

The only ones you really need to worry about are for the vacuum advance.
try this:

Cheers Mike

The vacum advance is one of the few I could figure out (work out what it dose and where to put it) the rest well I'll just have a bit of a play

Cheers Reece