5M-GE or 3Y Flywheel Wanted

muddy_munke · Post by **muddy_munke** » Tue Nov 27, 2007 4:21 pm

Hi, After ringing lots of places etc, I'm struggling to find me a Flywheel for my 5M. Can anyone help me? Also a 7M Sump Cover would be handy too

P.M or Reply here...
Cheers Daniel

Jafa · Post by **Jafa** » Tue Nov 27, 2007 4:23 pm

muddy_munke wrote:Hi, After ringing lots of places etc, I'm struggling to find me a Flywheel for my 5M. Can anyone help me? Also a 7M Sump Cover would be handy too

P.M or Reply here...
Cheers Daniel

You can use a 3Y flywheel, you just have to move 1 bolt hole a little bit

muddy_munke · Post by **muddy_munke** » Tue Nov 27, 2007 4:31 pm

Really

Sweet. Could be easier to find! By move one hole, do you mean slog it out or re-drill it or.....
If I get one will I know what ya mean

Cheers Daniel

Jafa · Post by **Jafa** » Wed Nov 28, 2007 9:09 am

Yep just slot one hole a bit

SupraLux · Post by **SupraLux** » Wed Nov 28, 2007 11:00 am

muddy_munke wrote: By move one hole, do you mean slog it out or re-drill it or.....

Its a flywheel - a large heavy solid mass spinning at high speed just beside your legs... get it slotted in a mill properly

Its just one hole that is not quite in the right place, but still on the same PCD as the others, so it needs slotting by about half-a-hole...

Or I can get you a new one custom made, but they work out around $450-500, where you should be able to pick up a 3Y one dirt cheap (sold my last whole motor, fan to clutch for $150)

Steve

muddy_munke · Post by **muddy_munke** » Wed Nov 28, 2007 3:58 pm

Ha, Yeah I was thinking that.. But its all good. I might have one lined up aslong as it doesn't have cracks or anything in it. If all else fails. I'll be in touch Steve

Cheers Daniel

5M-GE or 3Y Flywheel Wanted

5M-GE or 3Y Flywheel Wanted

Re: 5M-GE Flywheel