Offroad-Express

Posted: **Tue Dec 04, 2007 8:33 pm**

can any of the more experienced peoples out there tell me what would be involved to get from the above to the below :?:

always wanted a project

Posted: **Tue Dec 04, 2007 8:41 pm**

it would be a good project!! but a lot of time involved if you were to do it your self? or expensive if you were to pay someone?
can you weld etc?

Posted: **Tue Dec 04, 2007 8:46 pm**

mmmm...me and welding...a dangerous combo.... :roll:

general skills...average

would defintely need guidance :wink:

Posted: **Tue Dec 04, 2007 8:47 pm**

depends if you want it to be road registerd etc

Posted: **Tue Dec 04, 2007 8:48 pm**

brianr70 wrote:
can any of the more experienced peoples out there tell me what would be involved to get from the above to the below

always wanted a project

I know that truck - basically it's had the chassis shortened, body chopped, rollcage added & guards beaten out with a big hammer to fit 33's & that's about it - still IFS & standard motor - that said it goes OK in the bush & has been a good toy for him.

Posted: **Tue Dec 04, 2007 8:49 pm**

brianr70 wrote:mmmm...me and welding...a dangerous combo....

general skills...average

would defintely need guidance

if i were up that way i would give you a hand......there must be some local ORE guys up there to help?

Posted: **Tue Dec 04, 2007 11:14 pm**

I'm not that skilled, But if you don't want it to be road legal i could probly weld for you:D. My dad taught me how to do this sorta stuff. Look for my father son project thru off topic and see what you think. I did all the welding.

Offroad-Express

Possible project???

Possible project???

Re: Possible project???