Offroad-Express

just did another front diff in. that makes two in two years.

almost make it up a near 45 degree plus hill climb lifted the front wheels over the top edge then there was a loud clunk as i touched down and what do ya know this is the result


sorry not a very good photo.
looking at the housing from the rear. the bit to the left is the mount the bit to the right of that is half of the input shaft entry hole running back nto the diff head.

the bottom part of the housing smashed out letting the drive shaft and drive cog flop free. and exposing the internals

Oooo Bugger,
Atleast you destroyed it good and proper. None of that half assed bending things.
Hope you can track down a new one!!

yeh when i do things i dont do them by halves lol.

if is bented or dented its not broken, if its n pieces its broken, and if its been smashed and bashed then its f@#ked lol

i think i know where a couple of diffs are.

im goin to sas it though eventually i think