Offroad-Express

Posted: **Thu Jan 24, 2008 10:01 pm**

spigot bearing?

the listing i get from auto parts places is 32od 15id by 10mm

but my torqu converter messures 19 and crank mesures 34

bearing shops say its a odd size and has to be made

any ideas?

cheer
sam

Posted: **Sun Jan 27, 2008 5:38 pm**

LOWDWN wrote:never had the chance to put a auto box back in sadly or never did a clutch on a auto car haha , now its time to asemble my engine, can one of you guys give me an order of parts? 6g72 auto

parts:
-80mm round ring drilled
-three sided large plate also drilled
-flexplate

need to know what order these are put...

ENGINE/CRANK to, ________ to, _________ to, __________ then ending in placing against TORQE CONVERTER

if that works for you lol

ALSO, planning on puting new fluid in torque converter, do i use the usual atf or is there a torque converter fluid?

and any secrets i need to know about when placing the torqu converter onto the input shaft

THANKS AGAIN!

anyonw know were i could find out this info?

Posted: **Sun Jan 27, 2008 11:26 pm**

i can only suggest a haines manual or sumthing. think they are bout $50 or so from places like repco etc.

Sam

Posted: **Thu Jan 31, 2008 8:32 am**

HI, I can help you when I get home. Been away for the week but will look in the manual then.

Sunday/Monday ish.

Offroad-Express

auto

auto

Re: auto trans fittment

Re: auto trans fittment

Re: auto trans fittment