Rattle gun needed - West Auckland

[Filthy4x4]

Hey guys

Just wondering if anyone has a rattle gun I could borrow for a couple of hours just to take off a flywheel and refit to new engine.

Prefer west auckland (west harbour)

I have a compressor and lines etc

Cheers

Caleb

[DieselBoy]

Just use a beaker bar and an pipe extention. Use a mate to hold the flywheel still with a jimmy bar or even a tie down around the flywheel attached to something like the engine stand or the tow bar of your truck.

A rattle gun is only as good as the compressor thats powering it. a little 2.5hp jobby won't cut it. Ya need a BIG ONE.

[Filthy4x4]

Just use a beaker bar and an pipe extention. Use a mate to hold the flywheel still with a jimmy bar or even a tie down around the flywheel attached to something like the engine stand or the tow bar of your truck.

A rattle gun is only as good as the compressor thats powering it. a little 2.5hp jobby won't cut it. Ya need a BIG ONE.

I dont have a breaker bar either I will try figure out a way to do it. My compressor should be fine its a decent sized industrial one

[kbushnz]

When do you need it.
I have one, in massey.
But I am at work, and I doubt the missus could find it.

Calvin

[Filthy4x4]

Just whenevers possible dude.
Thats nice and handy too

Cheers

Caleb

[kbushnz]

No Probs, check your PM's

Calvin