LJ50/80 front axle housing wanted

[LOLYF]

As the title says I'm needing one of these for a mate.
Around Auckland would be good but anything considered.

Cheers
Mark

[UBZ]

The LJ50 housing is approx 50mm narrower each side than the LJ80.
They have different spring spacing as well.

there are a few LJ50 ones floating around but LJ80 are pretty rare.

[LOLYF]

Cheers for that Chris, didn't realize the 80 was wider I guess as long as it came with axles it could be made to work. Spring spacing won't be an issue, Jono is pretty handi with a welder

Don't happen to have or know of any do you?

[LOLYF]

Bump...still need one of these

[DieselBoy]

Ok ok, I will get off my arse go and see what I have.

The reason I haven't yet is because I'm not sure if I have any good ones, as in they probably have rusty spring purches or worse.......

Johno has the Cappuccino powered LJ50 right??

[mercutio]

Johno has the Cappuccino powered LJ50 right??

I like the sound of that I was looking at doing the cappuccino transplant to my little suzuki then I found out the k series motors had the same bolt pattern and that was my ultimate setup unfortunately I sold it still regret it

[LOLYF]

Ok ok, I will get off my arse go and see what I have.

The reason I haven't yet is because I'm not sure if I have any good ones, as in they probably have rusty spring purches or worse.......

Johno has the Cappuccino powered LJ50 right??

Cheers Pete,
If you have one with rusty perches that would be fine, Jono can whip up some new ones and it would be a big improvement from the bent one it has now.

It's actually a Wagon R motor, 1 liter 4 cylinder turbo

[mercutio]

It's actually a Wagon R motor, 1 liter 4 cylinder turbo

Thats the K series engine I mentioned now I am really envious that setup would have been awesome in my little car. There is also a 1200cc n/a version of that engine

Just reminding myself what I am missing

[LOLYF]

It's a great little motor, with 125hp and 690kg it has a better power to weight ratio than my Lexus powered hilux