Offroad-Express

Hi
I've got a kzj78 prado a '93, with the 1kz motor, have a problem with the exhaust exit into the driver side guard then down the side. Has anyone done a fix to tuck it out of the way? even a pain to build side bars around.
If anyone has a fix they have done am keen to hear and pics would be great.
Thanks

hey dude, im goin thrugh an exhaust build now and was thinking about how to do that. i dont really want to smash in the bulkhead there. so im keen for that answer too, as im building a new dump pipe there i may be able to change the angle of the exit point a bit but its tight in there huh.

Mine and a mates goes down the inside, above the trans, but it'll cost $$$'s

any chance of a pic or two before i build my dump pipe??

wjw wrote:Mine and a mates goes down the inside, above the trans, but it'll cost $$$'s

Thanks for the reply, how close to the floor and brake lines have you gone?
will look at this option to see if I can run it there to, A pic or two would be great if you had the time to get them up.
Thanks

chop out the fire wall a bit? move the lines over and run strait down, or hammer it in

When it stops raining I'll take some photos...