WTD: 413 panel work

Selling, info, or parts wanted. Anything about parts goes in here.
Post Reply
User avatar
Swamped
Hard Yaka
Posts: 1264
Joined: Sun May 25, 2008 10:19 pm
Location: North Island

WTD: 413 panel work

Post by Swamped »

Am after just the c-pillar from a 413. Drivers side especially but both would be great. Even the left overs from someones ute chop would be fine as the uppers are needed more than the lower sections. Would take a whole tub if its been trashed in a roll and the rear is ok.
Prefer Waikato area but anywhere between say whangarei and waiouru would be considered unless is just a small section and can be couriered.

(And yes I know its a good excuse to cut the body down into a 2 seater but thats not what I have planned) :)

The cheaper and tidier the better!!!

Cheers...
User avatar
Swamped
Hard Yaka
Posts: 1264
Joined: Sun May 25, 2008 10:19 pm
Location: North Island

Re: WTD: 413 panel work

Post by Swamped »

Bump...

Surely someone has an old tub laying around....
Post Reply

Return to “4WD Parts”