Offroad-Express

The opinions and viewpoints expressed by users of Offroad-Express Forums are wholly their own and not necessarily those of Offroad-Express.
https://www.offroadexpress.kiwi:443/Forums/

Transfer case swap 249 to 242

https://www.offroadexpress.kiwi:443/Forums/viewtopic.php?t=26051

Page 1 of 1

Transfer case swap 249 to 242

Posted: Sat Jun 04, 2011 7:42 pm
by tga_4x4
Just scored a 242 case from a 96 XJ for $200 now time to throw out the 249 full time 4wd case...

Re: Transfer case swap 249 to 242

Posted: Sun Jun 05, 2011 6:58 pm
by xj
Make sure the input shaft is the right one, .840inch. If it is then all the wiring should be in the correct spots too.

http://www.offroadexpress.co.nz/Forums/ ... 32&t=25800 for any reference assistance.

Re: Transfer case swap 249 to 242

Posted: Sun Jun 05, 2011 8:39 pm
by tga_4x4
xj wrote:Make sure the input shaft is the right one, .840inch. If it is then all the wiring should be in the correct spots too.

http://www.offroadexpress.co.nz/Forums/ ... 32&t=25800 for any reference assistance.



Sure is the .840 just measured it now..

Re: Transfer case swap 249 to 242

Posted: Wed Sep 14, 2011 10:33 pm
by xj
how did ya get on?
All times are UTC+12:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited