front driveshaft for the mu
Posted: Wed Mar 14, 2007 7:53 pm
..
It always pays (as I'm sure you've figured out by now
) to mark everything with a white marker before you start pulling it apart...
Steve
Offroad-Express
The opinions and viewpoints expressed by users of Offroad-Express Forums are wholly their own and not necessarily those of Offroad-Express.
https://www.offroadexpress.kiwi:443/Forums/
front driveshaft for the mu
https://www.offroadexpress.kiwi:443/Forums/viewtopic.php?t=5202
Page 1 of 1
Posted: Thu Mar 15, 2007 5:36 pm
I think the sleeve goes to the top from memory but it shouldn't affect the operation... just make sure you have the UJs aligned (if you've slipped the slip-joint apart) otherwise you could end up with driveline vibration.
It always pays (as I'm sure you've figured out by now ) to mark everything with a white marker before you start pulling it apart...
Steve
It always pays (as I'm sure you've figured out by now
) to mark everything with a white marker before you start pulling it apart...
Steve
Posted: Fri Mar 16, 2007 4:26 pm
..
Posted: Fri Mar 16, 2007 7:21 pm
It doesn't matter what way you putt the drive shaft in so long as both UJ's are in line, as the diff is fixed in place. So long as your not doin high speed in 4wd you shouldn't need to get it balanced.
Nathan
Nathan
Posted: Fri Mar 16, 2007 7:51 pm
on ma piece of broken shit the sleeve that the shaft slides in to is on transfer case end
Posted: Fri Mar 16, 2007 9:52 pm
..