Thanks abbo....
Water leak
Water leak
Hi there , i have a 92 3.1 and its starting to eat water . It looks like its coming from the side of the motor....Is there frost plugs there??? Just replaced cap which needed replacing . When you turn the car off there sound like a air leak??? Could this be part of the problem.
Thanks abbo....
Thanks abbo....
Re: Water leak
ya sure its not heat escaping from the heated seats?
swb lux with 7mge, trailgear crossover, trailgear rear lift kit, custom front bar, runva 1200lb winch, custom snorkel, 37" Mtrs, custom deck, lockright in the rear.
-
mud_slinger
- Hard Yaka
- Posts: 1050
- Joined: Sun Oct 08, 2006 12:00 pm
- Location: christchuch
Re: Water leak
mud_slinger wrote:what side of the engine?
Its on the left hand side of the motor. I can sort of see where its coming from. Need to out up on stands.
Thanks for reply.
Don't have 4wd.
Re: Water leak
haynzy wrote:ya sure its not heat escaping from the heated seats?
Loving them heated seats but dont think its from there....
Don't have 4wd.
-
mud_slinger
- Hard Yaka
- Posts: 1050
- Joined: Sun Oct 08, 2006 12:00 pm
- Location: christchuch
Re: Water leak
could be a frost plug but behind the back of the engine are 2 waterlines which could be your issue. if it is them good luck they arent very nice. they go to your oil cooler on the drivers side dont qoute me on where the oil cooler is as i,m more familiar with the 2.8 engine
needs more curry
0272593533
0272593533
-
RobLucking
- Bush Crasher
- Posts: 60
- Joined: Wed Jun 29, 2011 6:51 pm
Re: Water leak
^^^what he said.
they get pretty brittle and crack quite easily. if you want to replace without ripping engine out, you will need to bend some of your inner gaurd back and have skinny hands.
took me about 3 hours to replace hose with many swear words
stupid isuzu design
they get pretty brittle and crack quite easily. if you want to replace without ripping engine out, you will need to bend some of your inner gaurd back and have skinny hands.
took me about 3 hours to replace hose with many swear words
stupid isuzu design
Re: Water leak
I got a pinhole in one of the steel tubes that run behind the block and it took a while to find as it is all mixed up with the inlet manifold and feeds to the heater.
What they said about replacement ... It's a pain made only a little easier when I had to take the exhaust manifold off
What they said about replacement ... It's a pain made only a little easier when I had to take the exhaust manifold off
There is no mechanical problem so difficult that it cannot be solved by brute strength and ignorance.