rear 80 series springs wanted

sg8380 · Post by **sg8380** » Fri Oct 12, 2012 3:47 pm

hey im after some rear 80 series landcruiser springs to put in a ln130 surf

Thanks, Sam

Smurf · Post by **Smurf** » Fri Oct 12, 2012 6:07 pm

How are you going to level out the front once you have lifted the rear 4 or more inches?

rowdyrunner · Post by **rowdyrunner** » Sat Oct 13, 2012 8:18 am

Gidday i can get you a pair of them cheap if you like. PM me

Big · Post by **Big** » Sun Oct 14, 2012 6:48 pm

got some.. pm me if needed..

sg8380 · Post by **sg8380** » Sun Oct 14, 2012 8:57 pm

hey ill just wind the torsion bars up in the front, my mate has just done it to his and it looks good

evolution02 · Post by **evolution02** » Tue Oct 16, 2012 8:09 pm

Smurf wrote:How are you going to level out the front once you have lifted the rear 4 or more inches?

Smurf says this as you can only get about 2 inches out of the torsion bars. If you wind them to far you will be against the bump stops and have no travel left

sg8380 · Post by **sg8380** » Tue Oct 16, 2012 8:22 pm

whats the other option i have to raise it?

jonossiksilvia · Post by **jonossiksilvia** » Tue Oct 16, 2012 8:38 pm

sas but not a cheap option

sg8380 · Post by **sg8380** » Tue Oct 16, 2012 9:09 pm

Just wondering what an sas is? Haha

keithal · Post by **keithal** » Tue Oct 16, 2012 9:12 pm

sas is a solid axle swap
there have been a few done recently on here
have a look in Tomsoffroad thread and you will see jammysammy's surf with a prado front axle

sg8380 · Post by **sg8380** » Tue Oct 16, 2012 9:50 pm

What would the cheapest and easiest option be to raise it

keithal · Post by **keithal** » Tue Oct 16, 2012 9:57 pm

50mm spring lift/shocks in the rear and wind the torsions to suit

sg8380 · Post by **sg8380** » Wed Oct 17, 2012 8:12 pm

Do front springs off a 80 series land cruiser fit in and give it a 50 mm lift from standard height?

Smurf · Post by **Smurf** » Wed Oct 17, 2012 8:54 pm

80 series fronts are a different diameter coil and don't fit. Will also lift higher than the 80 series rear.

sg8380 · Post by **sg8380** » Thu Oct 18, 2012 5:47 am

Ok thanks for that ill just stick to the 50mm lift springs then

rear 80 series springs wanted

rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted

Re: rear 80 series springs wanted