where to buy alloy fiarlead with offet holes to fit arb bar

[ToyRover]

need one like tiger11 on trade me use to sell with the holes off set down so i can use bolts that hold winch in to hold it any help would be good

[sibainmud]

Like this one?


Try Tigerz 11. Brett good to deal with.
http://www.tigerz11.co.nz/Winch_Accessories.php

Cheers,

[T-Boon]

http://www.4wdbits.co.nz/ProductsList.a ... egoryID=23

3 Sizes, unsure which one you might need?







Bit Pricier than the Tigerz ones though, maybe drop them a line and see if they can budge?

[sibainmud]

^^^^^^
They look off-set
I have used one of those though, in an off-set application. You just need a few special tools, e.g, Drills to suit a large tap (10-13mm)(3/8-1/2) and a counter bore cutter to make a couple of holes in the back to accommodate the winch lower mount bolts.

The lower holes are the centre of the bored out voids.

Cheers,

[badnuz]

try your local ARB shop?

[3VILC]

I had the same issue on my old truck. My uncle "borrowed" a bit of 15mm alloy plate from the paper mill where he works and chucked my drawing into the CNC cutter..only issue was, he figured I had measured wrong on the drawing and he moved the holes back to the center lol

[ToyRover]

^^^^^^
They look off-set
I have used one of those though, in an off-set application. You just need a few special tools, e.g, Drills to suit a large tap (10-13mm)(3/8-1/2) and a counter bore cutter to make a couple of holes in the back to accommodate the winch lower mount bolts.

The lower holes are the centre of the bored out voids.

Cheers,

has the rope ever rubed on the lip where the rollers bolted on to

[sibainmud]

Nah not really. I was going to cut it off and weld a smaller bit of material to it as a strong back.....but.......I'm going to have to retire that bar soon as it suffered some serious warpage last weekend and is almost past saving.

Cheers,